Filter
Top Products
239
Control systems
COMAND seats
̈ Confirming selection: Press n.
Cross-hairs appear. You can use them
to make two settings:
ț vertical: shift the point of greatest
curvature upward or downward
ț horizontal: adjust the degree of
curvature
̈ Slide qmr or omp until desired setting
is reached.
̈ Saving setting: Press n.
Adjusting backrest curvature in shoul-
der area
This function is used to adjust the air
chambers in the shoulder area of the back-
rest.
̈ Select seat (୴ page 236).
̈ Selecting “Shoulders”: Slide omp or
rotate ymz.
̈ Confirming selection: Press n.
A scale appears.
̈ Slide qmr or rotate ymz until desired
setting is reached.
̈ Saving setting: Press n.
Adjusting seat firmness
̈ Select seat (୴ page 236).
̈ Selecting “Seat Firm.”: Slide omp or
rotate ymz.
̈ Confirming selection: Press n.
A scale appears. You can choose be-
tween:
ț “0”: off
ț “1”: level 1
ț “2”: level 2
̈ Slide qmr or rotate ymz until desired
setting is reached.
̈ Saving setting: Press n.