140
Controls in detail
Good visibility
Activating exterior rear view mirror
parking position
Follow these steps to activate the mirror
parking position so that the passen-
ger-side exterior rear view mirror will be
turned downward to the stored positions.
̈ Make sure you stored a parking posi-
tion for the passenger-side exterior
rear view mirror (
୴ page 95)
̈ Make sure that the
MIRROR SETTING
WHEN PARKING
function, found under
the
CONVENIENCE
submenu in the con-
trol system, is switched to
ON
(
୴ page 124).
̈ Switch on ignition.
̈ Press button 2 (୴ page 40) for the pas-
senger-side exterior rear view mirror.
̈ Place the gear selector lever in reverse
gear R .
The passenger-side exterior rear view
mirror will be turned downward in the
stored position.
The exterior rear view mirror returns to its
previously stored driving position:
ț 10 seconds after you put the gear se-
lector lever out of position R
ț immediately once you exceed a vehicle
speed of approx. 6 mph (10 km/h)
ț immediately when you press the button
for driver’s side mirror (
୴ page 40)
Headlamp cleaning system*
The switch is located on the left side of the
dashboard.
1 Headlamp washer switch
̈ Switch on ignition.
̈ Press switch 1.
The headlamps are cleaned with a
high-pressure water jet.
Information on filling up the washer reser-
voir can be found in the “Operation” sec-
tion (
୴ page 232).