Filter
Top Products
120
Controls in detail
Control system
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U, the locator lighting fea-
ture is activated, and the vehicle is un-
locked by remote control:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
To activate locator lighting:
̈ Make sure the function
LOCATOR
LIGHTING
is set.
̈ Turn the exterior lamp switch to posi-
tion
U.
The locator lighting switches off when the
driver’s door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
̈ Move the selection marker with
the
æ or ç button to the
LIGHT-
ING
submenu.
̈ Press button j or k repeatedly
until you see this message in the dis-
play:
LOCATOR LIGHTING
.
The selection marker is on the current
setting.
̈ Press æ or ç to select the de-
sired setting.
The locator lighting will be switched on
or off.
Setting night security illumination
(Exterior lamps delayed shut-off)
Use the
HEADLAMPS DELAYED SHUT-OFF
function to set whether and for how long
you would like the exterior lamps to illumi-
nate during darkness after all doors are
closed.
When the delayed shut-off feature is acti-
vated and the exterior lamp switch is in po-
sition
U, the following lamps will
remain lit after you remove the key from
the starter switch:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
To activate night security illumination:
̈ Select delayed shut-off period (see be-
low).
̈ Turn the exterior lamp switch to posi-
tion
U.
i
You can reactivate this function within
ten minutes by opening a door.
If you do not open a door after remov-
ing the key, the lamps will automatical-
ly switch off after 60 seconds.