Filter
Top Products
40
down list will appear showing all of the available skins. Choose one
from the list and the iWAY will display the new skin automatically.
Screenshots throughout this manual were taken using the "Default" skin
mode. Other skin options will be available on the Lowrance web site in the
future.
Keyboard
Keyboard allows you to choose the layout of the buttons on the iWAY's
virtual keyboard. Use this option to choose the layout you are most fa-
miliar with so you can enter text information quickly and easily.
Brightness
The Brightness Slider controls the brightness of the screen. High levels
of brightness could make the iWAY difficult to read, especially during
night use. Low levels can make the screen seem too dark for easy view-
ing. Use the slider bar to adjust your screen's brightness to your prefer-
ence. To increase your screen's brightness, press and drag the button
on the slider bar to the right. To decrease screen brightness press and
drag the button to the left.
Transparency
The Transparency Slider controls the transparency of information and
navigation boxes that appear on the map page. Increasing transpar-
ency will make it easier to see the background map, but may interfere
with the legibility of the Overlays. Decreasing transparency clarifies
Overlays but it also obscures underlying map information.
To increase transparency, press and drag the button on the slider bar
to the right. To decrease it, press and drag the button to the left.
Calibrate Screen
The Calibrate Screen command is used to correct any differences be-
tween the location you press on the touch screen and the location the
iWAY thinks you pressed. If you find that the iWAY isn't responding
perfectly to your touch screen input run the calibrate screen command.
Select the
INTERFACE SETUP command (Options, Page 2) which will bring
up the Interface Options menu. In the Interface Options menu select
the
CALIBRATE SCREEN button. The Touch Screen Calibration menu will
appear, as shown in the following image, with a small target icon
somewhere on the screen. A test message asks you to press the center
of the target. When you do a new target will appear elsewhere on the
screen.