Filter
Top Products
The map scale is also changed by using the left cursor button. To change
the map scale, press the left C to place the cursor over the map scale
factor at the bottom left corner of the map display. Turn the left inner knob
to select a map scale. The map scale choices are the same as for the
NAV 5 page except there is an additional choice, AUTO, that is located
between the 1 nm scale factor and the 1000 nm scale factor. The AUTO
scale factor will automatically choose the smallest map scale that will dis-
play the active waypoint and, if there is one, the waypoint after the active
waypoint. Choosing the AUTO scale factor means there is one less item
for you to worry about. This is especially helpful when conducting non-pre-
cision approaches using the KLN 90B.
Like the NAV 5 page, the Super NAV 5 page shows a graphics depiction
of the direct to waypoint or the waypoints making up the active flight plan.
But the Super NAV 5 page shows alphanumeric waypoint identifiers on
the graphics display to make orientation even easier for you.
You may elect to have nearby VORs, NDBs, and/or airports added to the
graphics display. To do so, press the right C to display a pop up menu
on the right side of the screen. Notice from the menu that a circle with a
dot in the center represents a VOR, a smaller circle represents an NDB,
and a small diamond represents an airport. The VORs, NDBs, and air-
ports displayed are those from the nearest waypoint lists described in sec-
tion 9.0, “NEAREST AIRPORTS, VORS, AND NDBS.”
When the menu is first displayed the cursor will be on the VOR selection
field. Rotate the right inner knob to display one of the following: TLH, LH ,
H or OFF.
TLH - Terminal, low altitude, and high altitude VORs are selected. In
addition, VORs of undefined class will be displayed. In some parts of the
world VORs are not classified into one of the three standard classes;
therefore, TLH must be selected to display these undefined class VORs.
LH - Only low altitude and high altitude VORs will be displayed.
H - Only high altitude VORs will be displayed.
OFF - No VORs displayed
In a like manner, NDBs and/or airports may be selected by first using the
right outer knob to move the cursor over the NDB or APT selection field
and then using the right inner knob to select ON or OFF.
The map orientation can be changed by moving the cursor to the bottom
line of the pop-up menu and rotating the right inner knob. The map orien-
20