Filter
Top Products
If this condition isn’t occurring, then:
3. If there is any waypoint page (APT 1-8 page, VOR page, NDB page, INT
page, SUP page, or ACT page) in view on the right side when D is
pressed, then the Direct To page will contain the identifier for the way-
point page being viewed on the right side.
If neither of the conditions above are occurring, then:
4. When D is pressed, the waypoint identifier for the current active
waypoint will be displayed.
5. If there is no active waypoint when D is pressed, then the Direct To
page displays blanks.For there not to be an active waypoint, there can
be no Direct To waypoint and no waypoints in Flight Plan 0.
The application of rules 1and 2 are described in section 13.4, “Combining
Direct To And Flight Plan Operation.” With the other in mind, here are
three procedures for initiating Direct To navigation.
4.1 Direct To - Procedure A
• Press D. The Direct To page is displayed on the left side. The cursor
will already be on the left page. A waypoint identifier may or may not be
displayed, it doesn’t matter at this point.
• Rotate the left inner knob to select the first character of the desired way-
point’s identifier. Remember to enter the “K”, “C”, or “P” prefix for certain
airports, if required (see section 2.2, “Entering Waypoint Identifiers”).
• Turn the left outer knob one step clockwise to move the flashing portion
of the cursor over the second character position.
• Rotate the left inner knob to select the second character of the identifier.
• Use the left outer and inner knobs as in the previous steps until the
desired identifier is completely displayed.
• Press E to display the waypoint page on the right side for the selected
waypoint. (If an incorrect identifier has been entered, you may immedi-
ately start using the left inner knob to re-enter the correct identifier.)
• Press E again to approve the displayed waypoint page. The right side
will display the NAV 1 page and the left side will return to the page which
was displayed prior to pressing D (unless the NAV 1 page was on the
left side or the Super NAV 5 page was selected, in which case the pages
will revert to the state they were in prior to the direct to operation). The
selected waypoint is now the active Direct To waypoint.
13