Filter
Top Products
Once the data card has been
read, a summary screen will
appear. Press ENTER/MARK
to acknowledge.
88
Appendix H
Installing and Removing
Data Cards
Installing and Removing Data Cards
The GPSMAP 182/182C/232 uses optional Garmin marine BlueChart and MapSource data cards to
display digital charts and maps on-screen. Data cards are installed in the card slot located at the bottom
right of the unit. Data cards may be installed or removed at any time, whether the unit is on or off.
To install a data card:
1. Open the card door by pressing together on the two handles at the bottom of the door and
lifting it up and open.
2. Insert the card, with the label facing front and the handle bottom, into the slot.
3. Firmly push the card into the unit. It in not necessary to force the card and about 1/2” will still
be exposed when it is properly inserted. If the unit is on, a confi rmation tone will sound and
a message will display on the screen noting the card details when the card has been properly
installed and accepted.
4. Close the cover.
If you insert a data card and get a ‘card format not recognized’ message, try removing the card and
reinserting it. If the card is still not recognized, contact Garmin Support or your Garmin dealer for
assistance. Data cards are not waterproof, should not be exposed to moisture or excessive static charges,
and should be stored in the case supplied with the card.
To remove a data card:
1. Open the card door by pressing together on the two handles at the bottom of the door and
lifting it up and open.
2. Grasp the card handle at the bottom and pull down fi rmly.
3. If the unit is on, a confi rmation tone will sound when the data card has been removed.
The fi rst time you insert a
data card, the unit will take a
few seconds to read the card.
182C Manual Part 2.indd 88 6/4/2003, 2:54:34 PM