Filter
Top Products
GPSMAP 182/182C Owner’s Manual 95
APPENDIX > MOUNTING THE GPSMAP 182/182C UNIT
To install the GPSMAP 182/182C unit:
1. Select the location of the mounting bracket.
2. Mark and drill the four mounting holes for the fastener you
are using.
3. Fasten the bracket to the surface using the appropriate
fastener.
4. Insert the GPSMAP 182/182C into the mounting bracket.
The bracket is designed for a tight fit to provide additional
support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into
the display case.
6. Connect the power/data and antenna cables (external
antenna only) to the back of the unit, making sure the
locking rings are fully tightened on both connectors.
The GPSMAP 182/182C with external antenna can be flush
mounted on a flat panel of .08-.52" thickness using the cam lobe
feature on its gimbal mounting bracket. When flush mounting
the GPSMAP 182/182C, be sure to choose an appropriately sized
location for the unit (see unit dimensions on page 93) and leave
1.25" (32 mm) clearance below the data card slot for inserting or
removing data cards.