Filter
Top Products
Messages &
Time Offsets
APPENDIX C
72
Active WPT Can’t be Deleted—You have attempted to change the “active to”’ or “active from”
waypoint. Clear the active route or GOTO before making your changes.
Accuracy has been Degraded—The accuracy of the GPS 125 Sounder has been degraded
beyond 500 meters due to poor satellite geometry or data quality. You should check other navi-
gational sources to verify the position indicated.
Already Exists—The name you are entering already exists in the GPS 125 Sounder’s memory.
Approaching—You are one minute away from reaching a destination waypoint.
Deep Water Alarm—The current depth is equal to or more than the set alarm depth.
No DGPS Position—Not enough data is available to compute a DGPS position.
No RTCM Input—
Beacon receiver is improperly connected or baud rates do not match.
Poor GPS Coverage—The GPS 125 Sounder cannot acquire the necessary number of satellites
to compute a position. Try another location with a clearer view of the sky.
Power Down and Re-init—The GPS 125 Sounder is not able to calculate a position due to
abnormal satellite conditions. Turn the unit off and verify the last position shown by other
means. Try the unit again later, possibly in a different location.
Read Only Mem has Failed—The permanent memory has failed and the unit is not operable.
Take your unit to an authorized GARMIN dealer for repairs.
Received an Invalid WPT—A waypoint was received during upload transfer that has an invalid
identifier.
Receiver has Failed—A failure in receiver hardware has been detected. If this message persists,
do not use the unit and take it to an authorized dealer for repair.
Route is Full—You have attempted to add more than 30 waypoints to a route.
Route is not Empty—You have attempted to copy into a route already in use.
Route Waypoint Can’t be Deleted—The waypoint you are trying to delete is part of a route.
Delete the waypoint from the route before removing it from memory.
Route Waypoint was Deleted—A route waypoint entered does not exist in the database and
has been deleted from the route.
RTCM Input has Failed—DGPS data being received has been lost. You are no longer receiving
the beacon signal.
Route Waypoint was Deleted—A route waypoint entered does not exist in the database and
has been deleted from the route.
The GPS 125 Sounder uses a flashing on-screen mes-
sage to alert you to important information. Whenever the
message indicator appears, press the PAGE key to view the
message page. There are two types of messages: temporary
alerts and condition alerts. Temporary alerts are cleared
from the message page after viewing, while condition alerts
remain on the message page until the condition has been
resolved. Pay careful attention to all messages for your
own safety.
125 Man Rev B 7/23/98 11:48 AM Page 72