Filter
Top Products
To go to a waypoint highlighted on the map:
1. Press the
G
key. The GOTO waypoint page will
appear with the waypoint’s name highlighted.
2. Press the
F
key to confirm.
To stop the panning function and display your
present position:
1. Press the
Q
key.
Using the Cursor to Mark and Go to Waypoints
During panning, the crosshair represents a target
position right on the moving map, with the range and
bearing to the target displayed at the top corners of the
screen. You can also use the target crosshair to mark a
new waypoint position or as a GOTO destination right
from the map field.
To mark the target crosshair position as a new
waypoint:
1. Press the
F
key to capture the position.
2. Enter a new name and route number and press
F
.
You can also use the target crosshair as an instant
GOTO destination. This function will mark and
instantly set a course for a new waypoint called ‘MAP’.
To GOTO the target crosshair:
1. Press the
G
key to capture the position.
2. Press the
F
key to confirm the MAP GOTO.
To save the MAP waypoint, rename it, as it will be
overwritten the next time a map GOTO is executed.
43
To mark a waypoint with
the crosshair, simply pan to
the desired position and
press the ENTER key.
REFERENCE
Using the
Cursor on the
Map
The crosshair may also be
used to define a GOTO des-
tination by panning to the
desired position and press-
ing the GOTO key. To save
the MAP waypoint, rename
it, as it will be overwritten
by the next MAP waypoint.
125 Man Rev B 7/23/98 11:48 AM Page 43