Filter
Top Products
To flush mount the GPS 125 Sounder:
The GPS 125 Sounder can be mounted flush with a
flat panel of .08-.52” thickness using the cam lobe fea-
ture on its mounting bracket.
1. Cut a 4.15” W x 4.67” H hole in panel.
2. Place GPS 125 Sounder into hole from the front until
its flange rests against the mounting surface.
3. From the back side of the panel, loosely attach the
bracket such that the slot in the ratchet area points
away from the mounting panel.
4. Rotate the bracket downward until the panel
is pinched tightly between the units flange
and bracket lobe.
5. Tighten knobs and connect the power/data, antenna,
and transducer cables.
69
APPENDIX A
Installation
125 Man Rev B 7/23/98 11:48 AM Page 69