Filter
Top Products
6-16
6.9 Recording, Replaying Data
6.9.1 Formatting memory cards
Before you can use a memory card (RAM card) with the RP-26, the card must be format-
ted. Formatting prepares the recording surface of the card for use with the system. Insert
a new memory card in the right side card drive and follow the procedure below to format it.
1. Press [NAV MENU], [6] to choose CARD.
2. If RECORD is not in reverse video, press the [6] key again.
3. Press the [ENTER] key.
[RECORD CARD]
1 [VIDEO PLOTTER 1]
2 OWN SHIP PLOT T
3 TARGET PLOT A
4 MARK M
5
6
7
8
9
0 FORMAT NO/YES
Figure 6-16 RECORD CARD menu
4. Press the [0] key twice to select YES.
5. Press the [ENTER] key.
6.9.2 Recording data
When the track memory becomes full, the oldest track is erased to make room for the
latest. Further, when the mark memory becomes full you cannot enter another mark un-
less you erase a mark. Thus you should save important data to a memory card.
1. Insert a formatted RAM card into the card drive.
2. Press [NAV MENU] and [6] to choose CARD.
3. If RECORD is not in reverse video, press the [6] key again.
4. Press the [ENTER] key.
5. Select item to record with appropriate numeric key:
[2]: Own ship’s track
[3]: Target track
[4]: Marks
[5]: Radar map
6. Enter file name. You may use ten figures.
7. Press the [ENTER] key.