Filter
Top Products
WHITE/BLACK WIRE: (-) HOOD/TRUNK TRIGGER (Mandatory For Hood Pin)
Input trigger for a grounding hood or trunk pin switch and to inhibit remote start if the hood is open. Connect to
existing hood and trunk pin switches that read ground when open. If no existing switches are available, install a
new pin switch. Note: DO NOT mount new pin switches in water pathways.
ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT (STARTER DISABLE)
Sends constant Ground output when system is armed. This output is used for adding a starter disable relay. For
starter kill, cut starter wire and connect between 87A and 30 on relay. Connect orange wire to 85 and connect 86 to
Ignition Source that has voltage in the ON and CRANKING position. Be sure to connect the Purple Remote Starter
Cranking output to the Motor side of the Starter Disable Relay or it will not allow the Remote Starter to operate.
VIOLET/WHITE WIRE: (-) OEM FACTORY DISARM OUTPUT
Provides a ground pulse to DISARM the vehicle’s FACTORY anti-theft system prior to Remote Start. Connect this
wire to the vehicles' anti-theft disarm wire. This wire may be found coming off the Driver's door key switch or the
Factory Anti-theft control module.
WIRING
WHITE/VIOLET WIRE: (-) OEM FACTORY ARM OUTPUT
Provides a ground pulse to ARM the vehicles' FACTORY after Remote Start. Connect this wire to the vehicle’s anti-
theft Arm wire.
BROWN WIRE: (+) SIREN OUTPUT (3 amp max.)
Connect to RED siren wire.
GRAY WIRE: (-) AUX. REMOTE OUTPUT #1 (Trunk Pop)
Provides Negative Pulse output for Factory Electronic Trunk Release. Requires relay for Positive type circuits.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT
Connect to switched parking light wire at back of light switch. If this is not possible, connect directly to one of the
parking lights at the front of the vehicle. European may vehicles require separate right and left circuits. Use a dual
relay or 2 diodes to separate the output signal.
BROWN/WHITE WIRE: (-) HORN HONK or (-) NEGATIVE IGNITION OUTPUT (Optional, Programmable)
Negative pulsed output for Horn Honk. Can also be programmed for an additional negative run output (Option #24).
2 PIN (BLUE) PLUG: PROGRAM / OVERRIDE BUTTON
2 PIN (RED) PLUG: LED INDICATOR (Red Flashing Light)
3 PIN DOORLOCK (WHITE) PLUG: