Filter
Top Products
Prior Intrusion
Diagnostics………………………….………………………………………………………...……….…..……22
Remote Start Operation……………….…………………………………………………………………………..….……..22-
23
Special LCD FM Remote-Pager
Functions……….…………………………………………………………..………………24
INSTALLATION CAUTIONS & WARNINGS
CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDOR shall not be responsible or liable in any way for accidents
or damage resulting from the use of this equipment. This system is designed to be professionally installed in a vehicle that is
in proper operating condition. Parking brake, Transmission, Throttle, and Engine Safety features must be in working order.
It is the vehicle owner’s responsibility to understand the operating features of this system.
DO NOT INSTALL CS2005FM ALARM/REMOTE STARTER in vehicles with MANUAL TRANSMISSIONS! There are no
safety features built into this unit for manual transmission vehicles. If accidentally left in gear, a remote started vehicle could
become a self-propelled threat to life and property.
INSTALLATION CAUTIONS & WARNINGS
DO NOT REMOTE START A VEHICLE IN A CLOSED AREA OR GARAGE! Make sure that door is open or there
is adequate ventilation is provided. Failure to observe this rule could result in serious injury or death from
poisonous Carbon Monoxide fumes! Also note this warning when programming this system for Cold Start
operation.
BEFORE BEGINNING INSTALLATION, check all vehicle manufacturer cautions and warnings regarding electrical
service. (AIR BAGS, ABS BRAKES, AND BATTERY).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering column,
or any other moving parts in the vehicle.
DO NOT EXCEED MAXIMUM OUTPUT RATINGS - SERIOUS DAMAGE MAY OCCUR. Limits for alarm and
remote start functions are listed in the main diagram and wiring descriptions page. If you are unsure about current
load, measure the load with an AMP-METER.
REMOVE MAIN SYSTEM FUSE(S) before jump starting the vehicle. DAMAGE MAY OCCUR TO SYSTEM IF
PROPER PRECAUTIONS ARE NOT OBSERVED.
DO NOT EXTEND REMOTE START/IGNITION OUTPUT HARNESS LENGTH. Locate the control module within
reach of the supplied IGNITION/START OUTPUT wires. Extending these wires could result in poor performance.