Filter
Top Products
18. REMOTE START ENGINE RUN TIME:
Controls the amount of running time for remote start: 12 or 24 Minutes.
19. COLD START INTERVAL TIME
Controls the time between remote engine starts when the “Cold Start” feature is activated: Every 1 or 2 hours.
20. TACH or TACHLESS MODE
Controls whether the system operates in Tachless mode or Tach mode using Engine RPM.
21. TACH LEARNING / GAS / DIESEL ENGINE
This option controls tach learning and engine type. There are 3 selections: Button #1 = System will learn tach
(ENGINE MUST BE AT IDLE). Button #2 = Set the system for GAS engine: Remote Start will occur 3 seconds after
IGNITION turns on. Button #3 = Sets the system for DIESEL engine: Remote Start will wait for 10 seconds before
remote starting to allow for Glow Plug warm-up.
22. ENABLE & LEARN 2-WAY FM PAGER
This option allows the system to operate with a 2-way remote pager expansion module and learn a Pager Remote.
Button #1 = Enables the system to work with the 2-Way paging expansion module. Button #2 is used when learning
a new 2-way FM remote/pager to the system. (See page 17 for 2-Way remote programming steps)
23. BROWN WIRE: MULTI-FUNCTION REMOTE START OUTPUT
This option allows you to configure how the system’s Brown Remote Start Output operates. There are three
choices: Button #1 = 2
nd
Ignition Output. Button #2 = 2
nd
Accessory Output. Button #3 = 2
nd
Starter Output
24. BROWN/WHITE WIRE: (-) NEG HORN HONK or NEG. IGN OUTPUT
This option allows you to configure how the system’s Brown/White wire operates. There are two choices: Button 1)
= Pulsed output for Horn Honk. Button 2 (Unlock) = Neg. Ignition output.
OPTION RESET PROCEDURE PROGRAMMING
OPTION RESET PROCEDURE (Restores ALL Values listed with an *):
1. Turn the Ignition ON and press the Program/Override button 5 times. The siren will chirp 3 times indicating you
are in programming mode.
2. Press the #3 Button on the Transmitter. The system will chirp (6) six times indication all options have been reset
to Default values (Column #1).
CUSTOM “PERSONAL” OVERRIDE CODE