Filter
Top Products
Programmable Auxiliary Output Channel #2.
BLACK/WHITE WIRE: (-) DOME LIGHT ILLUMINATION (Optional, Requires Relay)
Connect to terminal 85 of relay. This wire turns the dome light on for 30 seconds upon disarming of the alarm. If
the ignition is turned on or the alarm is re-armed, the dome light will turn off again. Connect this wire to terminal 85
of a relay. Connect terminal 86 to +12V Constant. Connect terminal 87 to +12V or ground depending on the type of
Dome Light/Door Pin circuit that is in the vehicle.
YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS
Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start”
positions.
BLUE/YELLOW WIRE: (+12V) DIESEL GLOW PLUG INPUT
Connect Pink wire to indicator circuit that shows +12 volts while the “WAIT TO START LAMP” is on. When this
wire is used, the CS-2013FM unit will wait until light turns off before attempting a remote start. Note: a relay may be
required for vehicles that have a Negative Wait to Start lamp circuit.
WIRING
BLUE/WHITE WIRE: (-) PASSENGER DOOR UNLOCK OUTPUT (Optional, requires relay)
This wire activates when the unlock button on the remote is pressed a second time upon disarming. Connects to
unlock circuit for passenger door or doors when using split Driver & Passenger unlock configuration.
BLUE/ORANGE WIRE: (-) NEGATIVE GROUND WHEN RUNNING (For Anti-Theft Bypass Module)
Sends a constant Ground with remote start command. Use this wire to activate a Bypass Modules.
BLACK WIRE: SYSTEM CHASSIS GROUND
Connect to chassis metal of the vehicle. Scrape away any paint or dirt from the connection point to ensure a good
connection.
RED WIRE: +12V POWER INPUT (15 amp fuse)
Connect to +12 Volt source. Recommended location for this connection is at the vehicle battery positive terminal.
VIOLET WIRE: (+) DOOR TRIGGER INPUT
This wire is used for vehicles that show a positive voltage (12 volts) when the door is open such as Ford.
GREEN WIRE: (-) DOOR TRIGGER INPUT
Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some isolated
door triggers. In this case you need to run an additional wires from the other doors or go directly to the wire that
triggers the vehicle’s dome light.