Filter
Top Products
ALARM OPERATION
DISARMING:
Press Button #1 (Lock Symbol) on the 2-Way remote. For the 1-Way remote Press Button #2 (Unlock Symbol) to
disarm. The 2-Way remote will confirm with an “UNLOCK” icon on the LCD display and an audible signal. At the
vehicle, the siren will chirp (2) times and the lights will flash (2) times. The red LED in the vehicle will turn off.
(Doors will unlock and the interior dome light will turn on if these optional features are installed.)
ONE-TIME SILENT ARM/DISARM: (1-WAY REMOTE ONLY)
Press the Button #5 (Side button) first, then press Button #1 or #2 and the system will arm/disarm without a chirps
just on a one-time basis.
SILENT ARM & DISARM: (Programmable)
The system can programmed to ARM and DISARM silently without Siren Chirps. See programming Option #3.
TRIGGERING THE ALARM:
After a short 15 second Arming delay (to allow vehicle/electronics to settle), the system becomes fully armed.
INTRUSION:
If there is an intrusion at the vehicle (door/hood/trunk opening) the alarm will sound for 45 seconds. The 2-way
remote will emit an audible melody, the LCD Display will a flashing icon to inform you which zone has been
violated.
SHOCK/IMPACT:
A hard impact or shock to the vehicle body will trigger the shock sensor and trip the alarm system for 20
seconds. as listed above. The LCD will display a hammer / crash icon. This may or may not mean that there is
actually damage on the vehicle, but it is a reminder to you that a harder impact was detected.
ALARM PRE-WARNING:
If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 5 quick siren chirps
and 1 light flash. The LCD remote will confirm with an audible warning and a small hammer icon.
PANIC FEATURE:
In the event of an emergency situation or to attract attention to your vehicle, press and hold Button #1 (Lock
Symbol) on either remote for at least 4 seconds. The Siren will sound and lights will flash for 40 seconds. The LCD
remote will emit and audible alert and the word “PAN” will display on the screen. Press Button #1 on either remote
to reset.
ONE-TIME SHOCK SENSOR BYPASS: