Filter
Top Products
This option controls whether the doors will lock when Passive Arming occurs. Note: May increase the risk of locking
keys in the vehicle. When selected ON, the alarm will lock the doors when passive arming.
9. REMOTE-LESS DISARM “BEACH MODE” (Note: this option also requires Passive arming/Passive locks)
This option allows the system to be disarmed without the remote as long as the key is inserted and turned ON within
10 seconds. This feature only operates after the system has passively armed. Upon opening the door, the siren
will chirp for 10 seconds, the key must be inserted and turned on, or the alarm will trigger. (See page 21 for
information.)
10. DOOR OPEN WARNING
This option controls the door the delay time in which the alarm system begins to monitor the Door circuit. If your
system begins to give you warning chirps because of delay dome light or courtesy lighting, then disable this option
by selection Button #2.
11. WHITE/RED WIRE: AUX #2 OR SECOND ARMED OUTPUT
This option controls the system’s White/Red Aux. #2 output. Button #1 = Auxiliary Channel #2 or Button #2 =
Constant Ground a a 2
nd
armed output when system is armed.
12. GRAY WIRE: AUX #1 OUTPUT CONFIGURATION
This option allows you to configure how the system’s Aux. Channel #1 output operates. There are two choices:
Button #1 = Pulsed. Button #2 = Timed-10 Seconds. Button #3 = Latched
13. WHITE/RED WIRE: AUX #2 OUTPUT CONFIGURATION
This option allows you to configure how the system’s Aux. Channel #2 output operates. There are two choices:
Button #1 = Pulsed. Button #2 = Timed-10 Seconds. Button #3 = Latched
14. DISARM WITH AUX. #1 OUTPUT (TRUNK POP)
Controls whether the system will or will not DISARM when the trunk pop or AUX. channel #1 is activated. When the
feature is turned ON, the unit will DISARM with trunk-pop or using an auxiliary device connected to the Gray wire.
15. REMOTE START WHILE IN VALET MODE
Allows to user to determine whether the system will allow a remote start when in Valet mode.
16. LOCK UPON REMOTE START
Controls whether the system will Lock or not lock when a remote start occurs.
17. LOCK UPON ENGINE SHUTDOWN / ABORT
Controls whether the system will Lock or not lock when a remote start “times out” or is aborted by the user.
OPTION PROGRAMMING