Filter
Top Products
Custom override allows the user to set a specific number of button presses (2 to 15) required to perform an
emergency override/disarm of the alarm system. This helps to defeat the common perception of a thief that if you
turn the vehicle’s ignition on and press the valet button, most alarms will shut down. This feature increases the level
of security of your alarm system, however MUST MEMORIZE how many button presses you have changed your
system to use or the unit will not disarm!!!
1. Follow steps to enter Option Programming mode. (See page 11)
2. Press program button 4 times to go to option #4 “Lock with Ignition/Custom Override”.
3. Press the Button #3 on the remote transmitter.
4. Carefully press and release the program/valet button the number of times you desire in order to perform
emergency disarm on this alarm system. Press the program button 2-15 times only.
To test feature: Set the alarm. Trip alarm system, turn key ON, press the program/valet button 2-15 times as
programmed above continuing to HOLD DOWN valet button on the LAST PRESS for 10 seconds. Alarm should
disarm. If system does not disarm, then disarm with the remote transmitter and try again. If system still does not
disarm, then repeat steps above.
REMOTE SENSOR ADJUST MODE (USE 1-WAY REMOTE ONLY!)
1. Turn Ignition ON and press button #5 (side button) on the 1-Way remote 3 times, then press Button #3.
2. The siren will chirp 4 times indicating that the system is in Sensor Adjust mode.
3. You can now carefully produce some vibrations around the vehicle such as kicking a tire or slapping a bumper.
When you produce an impact that would normally trigger the Pre-Warning level, the siren will chirp twice. When
you produce an impact that would normally trigger the shock sensor, the siren will chirp once. When finished
testing and adjusting the sensor, turn Ignition OFF, then back ON to clear this mode.
TRANSMITTER PROGRAMMING: 1-WAY REMOTES
1. Turn ignition on and off 3 times within leaving it on the 3
rd
time. (on/off, on/off, on) Wait for 3 seconds and siren
will chirp 3 times if this was performed correctly.
2. Press the override/program button for approx. 5 seconds until 5 siren chirps are heard. LED also comes on
solid.
3. Press and release Button #1 on the remote. The siren will chirp once. Press Button #1 AGAIN, you should hear
2 chirps on the second press for code-learn confirmation. Sometimes it takes a 3
rd
press to get the remote to
learn.
4. Repeat step #3 for up to a total of (4) 1-Way remotes.
5. Turn the ignition off and wait a few seconds before trying new remotes.