Filter
Top Products
39
➤ Arming and disarming diagnostics (including warning
responses) are reported by the transceiver on the LCD.
➤ When an open zone notification is generated during arming
the transceiver LCD will flash until the alarm is reset by the
ignition.
➤ To review zones that have been bypassed press 10
seconds after arming the system. The bypassed zones will
flash until the alarm is reset by the ignition.
➤ When a previous alarm notification is generated upon
disarming, the triggered zones will flash continuously on the
transceiver LCD until reset by the ignition.
➤ To review the zones that have been triggered press the
button. They flash five times, then turn off.
aannttii--ccooddee ggrraabbbbiinngg
The receiver and remotes use a mathematical formula called an
algorithm to change their code each time the transceiver is used.
This technology has been developed to increase the security of
the unit. The control unit knows what the next codes should be.
This helps to keep the transceiver “in sync” with the control unit
even if you use the transceiver out of range of the vehicle. How-
note: Your system stores the last two triggered zones in
memory. If your system has been triggered but the LED
has been reset by turning on the ignition, your dealer can
still recall the last two zones that were triggered. Contact
your dealer for details.