Filter
Top Products
31
override take-over
The Override Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Override Take-Over:
1. Before turning off the engine, simultaneously press and
release and on the transceiver. A remote start page
notification with a unique melody (or vibration) will be
generated and the LCD will display the remote start icon
(19) as long as the vehicle is running. Then wait three
seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous remote
engine start section for a complete list of shut-down inputs.)
setting the clock
To set the clock press and hold for five seconds, the trans-
ceiver will chirp twice and the hour selection will start flashing.
Immediately press to advance the hour selection or to
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing.
➜
note: This feature will not work if the brake pedal is
pressed or if any shut down input is active.
➜