Filter
Top Products
25
Pressing any button to clear the transceiver page and within
the first six seconds will stop the trigger response and disarm the
system. The six second timer is there for your convenience in
case the system was accidentally triggered.
disarming without a transceiver (emergency override)
If your transceiver is lost or damaged, you can manually disarm
your vehicle security system. To disarm the system without a
transceiver, you must have the vehicle's ignition key and know
where the override switch is located. Be sure to check with your
installer at the time of installation for both the location and the
preset response (1-5 presses) of the override switch.
To disarm the security system,
turn the ignition to the ON posi-
tion. Press the override switch the
preset number of times (one to
five times) within five seconds.
The factory preset is one. After
five seconds, the system will
disarm. If the system does not
disarm, you may have waited too
long; turn the ignition off and on
and try again.
Location of override switch_________________________________
Number of Presses_____________________________________
DRW-35
➜