Filter
Top Products
DISP (Display): Press this knob to switch the
display between the time and the temperature or
the radio station frequency and the temperature.
When the ignition is off, press this knob to display
the time.
To change the default on the display, press the
DISP knob until the desired option displays,
then hold the knob for two seconds. The radio
produces a beep and the selected display
becomes the default.
Finding a Station
AM/FM/CD: Press this button to switch between
FM1, FM2, AM, and CD. The selection displays.
ADJ (Adjust): Turn this knob to select radio
stations.
SEEK
w / SEEK x: Press the SEEK up button
or the SEEK down button to go to the next or
to the previous station and stay there.
To scan stations, press and hold either SEEK
button for two seconds until a beep sounds. The
radio goes to a station, plays for a few seconds,
then goes to the next station. Press either
SEEK button again to stop scanning.
To scan preset stations, press and hold either
SEEK button for more than four seconds until
two beeps sound. The radio goes to the first preset
station stored on the pushbuttons, plays for a
few seconds, then goes to the next preset station.
Press either SEEK button again to stop scanning
presets.
The radio only seeks and scans stations with a
strong signal that are in the selected band.
Setting Preset Stations
Up to 18 stations (six FM1, six FM2, and six AM),
can be programmed on the six numbered
pushbuttons, by performing the following steps:
1. Turn the radio on.
2. Press AM/FM/CD to select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons until a beep sounds. When
that numbered pushbutton is pressed, the
station that was set, returns.
5. Repeat the steps for each pushbutton.
230