Filter
Top Products
SEEK x: Press this button to go to the start of
the current track if more than eight seconds
have played. The track number displays. If this
button is pressed more than once, the player
continues moving backward through the CD.
If this button is held for more than two seconds, the
CD enters CD scan mode and the CD plays the first
10 seconds of each track. Press this button again to
stop scanning.
DISP (Display): Press this knob to see the
current track number, time, and temperature or the
track number, the elapsed time of the track, and
the temperature.
To change the default on the display, press this
knob until the desired option displays, then
hold the knob for two seconds. A beep sounds
and the selected display becomes the default.
AM/FM/CD: Press this button when listening to
the radio to play a CD.
EJECT /
Z(Eject): Press this button to eject a
CD. Eject can be activated with either the
ignition or radio off. CDs can be loaded with the
ignition and radio off if this button is pressed first.
CD Messages
If the CD comes out, it could be for one of the
following reasons:
• It is very hot. When the temperature returns to
normal, the CD should play.
• You are driving on a very rough road. When the
road becomes smoother, the CD should play.
• The CD is dirty, scratched, wet, or
upside down.
• The air is very humid. If so, wait about an hour
and try again.
• There could have been a problem while burning
the CD.
• The label could be caught in the CD player.
If the CD is not playing correctly, for any other
reason, try a known good CD.
If any error occurs repeatedly or if an error cannot
be corrected, contact your dealer. If the radio
displays an error message, write it down and
provide it to your dealer when reporting the
problem.
234