Filter
Top Products
6 (Delay/Intermittent Speed Sensitive):
When the lever is in the delay position, move the
intermittent adjust band to set for shorter or longer
delay cycles. To the left of the adjust band are bars
that indicate the frequency of the wipes. Smaller
bars mean the wiper movement is less frequent.
Larger bars mean the wiper movement is more
frequent.
During intermittent wiping mode, the delay cycle
time is sensitive to vehicle speed. As the vehicle
speed increases your delay cycle time will decrease
and wiper movement will occur more frequently.
9(Off): Move the lever to this position to turn off
the windshield wipers.
8(Mist): Move the lever all the way down
to mist and release for a single wiping cycle. The
windshield wipers will stop after one wipe and the
lever will return to its original position. If additional
wipes are needed, hold the band on mist longer.
As an added safety feature, if the wipers are on for
more than 15 seconds, the vehicle’s headlamps
will turn on automatically. They will turn off
15 seconds after the wipers are turned off.
Windshield Washer
To wash your windshield, push in the button at the
end of the stalk until the washers begin.
{CAUTION:
In freezing weather, do not use your
washer until the windshield is warmed.
Otherwise the washer fluid can form ice
on the windshield, blocking your vision.
When you release the button, the washers will
stop, but the wipers will continue to wipe for about
three cycles and will either stop or will resume
the speed you were using before.
174