5-137
Maintaining and Transporting the Printer | 137
5. Press to save the setting.
Using Maintenance Mode
Maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use
maintenance mode to do the following:
• Change the language or units of measurements used on the printer’s
control panel menus
• Change the default pressure setting for the automatic cutter
• Run a “super strong” cleaning cycle
• Enable power on roll paper feed
• Return all of the printer’s control panel settings to their default values
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the
Pause button, then press the P Power button and
hold it until the printer turns on and displays
MAINTENANCE.
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
• To change the language on the LCD display, press d to select
LANGUAGE, then press r. Press d until you see the language you
want, then press to select it. The printer exits maintenance
mode and returns to normal operation.
• To change the units of measurement, press d to select UNIT, then
press r. Press d to switch from
METER to FEET/INCH, then press
to select it.
• To change the default cutting pressure, press d to select CUT
PRESSURE
, then press r to display 100%. Press d to decrease the
pressure, or the u
button to increase it (in 1% increments). Press
to select the setting you want.
