Filter
Top Products
1 - 20
GEN
INFO
FEATURES
INSTRUMENT FUNCTION
Multi-function display
The multi-function display is equipped with the
following:
• a speedometer (which shows the riding
speed)
• an odometer (which shows the total dis-
tance traveled)
• two tripmeters (which show the distance
traveled since they were last set to zero)
• a fuel reserve tripmeter (which shows the
distance traveled since the fuel level warn-
ing light came on)
• a clock
• a self-diagnosis device
• a display brightness and engine speed
warning light control mode
NOTE:
_
• Be sure to turn the key to “ON” before using the “SELECT” and “RESET” buttons.
• For the U.K. only: To switch the speedometer display between kilometers and miles, press the
“SELECT” button and “RESET” button together for at least two seconds.
Odometer and tripmeter modes
Pushing the “SELECT” button switches the display between the odometer mode “ODO” and the trip-
meter modes “TRIP A” and “TRIP B” in the following order:
ODO → TRIP A → TRIP B → ODO
If the fuel level warning light comes on, the odometer display will automatically change to the fuel
reserve tripmeter mode “F-TRIP” and start counting the distance traveled from that point. In that
case, pushing the “SELECT” button switches the display between the various tripmeter and odome-
ter modes in the following order:
F-TRIP → TRIP A → TRIP B → ODO → F-TRIP
To reset a tripmeter, select it by pushing the “SELECT” button, and then push the “RESET” button
for at least one second. If you do not reset the fuel reserve tripmeter manually, it will reset itself
automatically and the display will return to the prior mode after refueling and traveling 5 km.
Clock mode
Turn the key to “ON”.
To change the display to the clock mode, push the “SELECT” button for at least one second.
To change the display back to the prior mode, push the “SELECT” button.
To set the clock:
1. Push the “SELECT” button and “RESET” button together for at least two seconds.
2. When the hour digits start flashing, push the “RESET” button to set the hours.
3. Push the “SELECT” button, and the minute digits will start flashing.
4. Push the “RESET” button to set the minutes.
5. Push the “SELECT” button and then release it to start the clock.
Self-diagnosis device
This model is equipped with a self-diagnosis device for various electrical circuits.
If any of those circuits are defective, the engine trouble warning light will come on and then, the
multi-function display will indicate a two-digit error code (e.g., 11, 12, 13).
1
Multi-function display
2
“SELECT” button
3
“RESET” button
4
Engine trouble warning light