Filter
Top Products
3 - 43
CHK
ADJ
ADJUSTING THE SHIFT PEDAL/
ADJUSTING THE DRIVE CHAIN SLACK
EAS00136
ADJUSTING THE SHIFT PEDAL
1. Check:
• shift pedal position
(distance
a
from the bottom of the rider
footrest bracket to the top of the shift pedal)
Out of specification
→
Adjust.
2. Adjust:
• shift pedal position
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Loosen both locknuts
1
.
b. Turn the shift rod
2
in direction
a
or
b
to
obtain the correct shift pedal position.
c. Tighten both locknuts.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS00140
ADJUSTING THE DRIVE CHAIN SLACK
NOTE:
_
The drive chain slack must be checked at the
tightest point on the chain.
CAUTION:
_
A drive chain that is too tight will overload the
engine and other vital parts, and one that is
too loose can skip and damage the swingarm
or cause an accident. Therefore, keep the
drive chain slack within the specified limits.
1. Stand the motorcycle on a level surface.
WARNING
_
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
_
Place the motorcycle on a suitable stand so
that the rear wheel is elevated.
2. Spin the rear wheel several times and find
the tightest position of drive chain.
Shift pedal position (below the
top of the rider footrest)
38 ~ 43 mm (1.50 ~ 1.69 in)
Direction
a
Shift pedal is raised.
Direction
b
Shift pedal is lowered.