Filter
Top Products
5 - 11
ENG
CAMSHAFT
EAS00198
REMOVING THE CAMSHAFTS
1. Align:
• TDC mark on the pickup coil rotor (with the
crankcase mating surface)
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Turn the crankshaft clockwise.
b. When piston #1 is at TDC on the compres-
sion stroke, align the TDC mark
a
on the
pickup coil rotor with the crankcase mating
surface
b
.
NOTE:
_
TDC on the compression stroke can be found
when the camshaft lobes are turned away from
each other.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
2. Loosen:
• camshaft sprocket bolts
1
3. Loosen:
• cap bolt
1
4. Remove:
• timing chain tensioner
2
• gasket
5. Remove:
• camshaft sprockets
1
NOTE:
_
To prevent the timing chain from falling into the
crankcase, fasten it with a wire
2
.