Yamaha PZ50Y PZ50RTY PZ50GTY PZ50MTY PZ50VTY Offroad Vehicle User Manual


 
Periodic maintenance and adjustment
59
9. Remove the engine oil drain bolt to drain
the oil from the crankcase.
TIP
Dispose of used oil according to local regula-
tions.
10. Install the engine oil drain bolts, and then
tighten them to the specified torques.
11. Add 1.5 L (1.59 US qt, 1.32 Imp.qt) of the
recommended engine oil to the oil tank,
and then install and tighten the oil filler
cap.
12. Start the engine, warm it up for several
minutes, and then turn it off.
13. Add sufficient oil of the recommended
type to raise it to the H level mark on the
dipstick. (See above for checking proce-
dures.) NOTICE: When adding the en-
gine oil, be careful not to fill above the
H level mark on the dipstick. Use
only the recommended oil. (See page
81.) Make sure that no foreign material
enters the engine oil tank.
[ECS00462]
14. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and make sure that the en-
gine oil drain bolt, oil tank drain bolt, and
the oil filler cap are installed correctly.
15. Turn the engine off, and then connect the
oil level gauge coupler.
16. Install the bottom panel and the right low-
er cover.
17. Install the right side cover (PZ50 /
PZ50RT / PZ50GT / PZ50MT), or install
the right side cover and the right upper
cover, and then close the shroud
(PZ50VT). NOTICE: If oil is leaking or
the oil level warning indicator comes
on when the engine is running, imme-
diately turn the engine off and have a
Yamaha dealer check the snowmobile.
Continuing to operate the engine un-
der such conditions could cause se-
vere engine damage.
[ECS00471]
1. Engine oil drain bolt (crankcase)
Tightening torques:
Engine oil drain bolt (crankcase):
30 Nm (3.0 m·kgf, 22 ft·lbf)
Engine oil drain bolt (oil tank):
16 Nm (1.6 m·kgf, 11 ft·lbf)
Recommended engine oil:
See page 81.
Oil quantity:
With oil filter cartridge replacement:
2.6 L (2.78 US qt, 2.31 Imp.qt)
Without oil filter cartridge replacement:
2.4 L (2.59 US qt, 2.16 Imp.qt)
Total amount:
3.0 L (3.17 US qt, 2.64 Imp.qt)
U8GK12E0.book Page 59 Monday, May 19, 2008 11:17 AM