Filter
Top Products
Periodic maintenance and adjustment
58
7. Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8. Connect the oil level gauge coupler.
9. Install the right side cover (PZ50 /
PZ50RT / PZ50GT / PZ50MT), or install
the right side cover and the right upper
cover, and then close the shroud
(PZ50VT).
To change the engine oil (without oil filter car-
tridge replacement)
1. Place the snowmobile on a level surface,
and apply the parking brake.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Remove the right side cover (PZ50 /
PZ50RT / PZ50GT / PZ50MT), or open
the shroud and remove the right upper
cover and the right side cover (PZ50VT).
(See page 49 for removal procedure.)
4. Remove the bottom panel and the right
lower cover.
5. Place an oil pan under the oil tank to col-
lect the used oil.
6. Disconnect the oil level gauge coupler.
7. Remove the oil filler cap and drain bolt to
drain the oil from the oil tank.
8. Place an oil pan under the engine to col-
lect the used oil.
1. Bottom panel
1. Right lower cover
1. Oil level gauge coupler
2. Oil filler cap
1. Engine oil drain bolt (oil tank)
U8GK12E0.book Page 58 Monday, May 19, 2008 11:17 AM