Filter
Top Products
Periodic maintenance and adjustment
50
To close the shroud and install the front cover
and air filter case cover
1. Insert the projections on the end of the air
filter case cover into the slots in the air fil-
ter case, place it in the original position,
and then tighten the fasteners.
2. Fit the holders on the front cover over the
projections on the air filter case cover,
slide the front cover downward, and then
hook the latch onto the holder on the front
of the snowmobile (PZ50 / PZ50RT /
PZ50GT / PZ50MT).
PZ50 / PZ50RT / PZ50GT / PZ50MT
Slowly lower the shroud to the original
position, and then hook the shroud latch-
es (PZ50VT).
Left side cover
To remove the left side cover
Loosen the fasteners, and then remove the
left side cover.
To install the left side cover
Place the left side cover in the original posi-
tion, and then tighten the fasteners.
Right side cover
To remove the right side cover
Loosen the quick fastener screws, and then
remove the right side cover.
1. Air filter case cover
2. Fastener
1. Projection on the end of the air filter case
cover
2. Slot in the air filter case
1. Holder on the front cover
2. Projection on the air filter case cover
1. Fastener
2. Left side cover
U8GK12E0.book Page 50 Monday, May 19, 2008 11:17 AM