Filter
Top Products
12
Specifications
General Specifications
Engine
Kubota three cylinder, 4 cycle liquid cooled diesel engine. 25 hp @ 3000 rpm for
Reelmaster 5200 and 31.5 hp @ 3000 rpm for Reelmaster 5400. Both governed to
3200 rpm. 68.5 cu. in. (1123 cc) displacement. Heavy duty, 3-stage, remote
mounted air cleaner. High water temperature shutdown switch.
Cooling System
Radiator capacity is approximately 7-1/2 qt. of 50/50 mixture of ethylene glycol
anti-freeze. Remote mounted 1 qt. expansion tank. A two speed fan drive controls
air flow from fan.
Fuel System
Fuel tank capacity is 9.5 gal. of #2 diesel fuel. Equipped with a fuel filter/water
separator to capture water in the fuel.
Traction System
Foot pedal controls forward/reverse ground speed. Ground speed: 0–10 mph
forward and 0–4 reverse. Hydrostatic transmission mounted directly on a 20.9:1
ratio front axle. Axle/reservoir capacity is 5 qt. Replaceable filter mounted directly
on transmission housing. Model 03544 only—mechanical rear axle is coupled to
front axle by a driveshaft and overrunning clutch.
Cutting Unit Drive System
Hydraulic reel motors feature quick disconnects to ease removal/installation on
cutting units. Hydraulic fluid reservoir capacity is 8 gal. System protected by a filter
assembly with service indicator.
Seat
Deluxe high back seat with adjustable fore and aft travel, weight and height. Tool
box at left side of seat.
Steering System Power steering with dedicated power source
Tires
Two rear tires: 20 x 10.00-10, tubeless, 6-ply rating. Two front tires: 26.5 x 14.00-12
tubeless, 4-ply rating. Recommended tire pressure for front and rear tires is 10–15
psi.
Brakes
Individual drum type wheel brakes on front traction wheels. Brakes controlled by
individual pedals operated by the left foot. Hydrostatic braking through traction
drive.
Electrical System
Automotive type electrical system. 12 volt, maintenance free battery with 530 cold
cranking Amps @ 0 degrees F. and 85 minute reserve capacity @ 85 degrees F. 40
amp alternator with I.C. regulator/rectifier. Seat switch, reel and traction interlock
switches. An electronic controller monitors and controls safety and operational
functions. Parking brake switch in steering column.
Controls
Foot operated traction and brake pedals. Hand operated throttle, traction speed
control lever, parking brake lock, ignition switch with automatic preheat cycle, single
joy stick control for cutting unit on/off and lift/lower. Cutting unit backlap switch and
reel speed controls located under control console.
Gauges
Hour meter, speedometer, fuel gauge, temperature gauge. 4 warning lamps: oil
pressure, water temperature, amps, and glow plug.
Diagnostics
The Automatic Control Electronics, ACET system allows precise timing and control
of machine functions for maximum reliability. Optional hand held diagnostic display
connects to an electronic control unit to pin point any electrical problems quickly
and easily. Available DATA LOG™ system allows mechanic to find intermittent
problems.