Filter
Top Products
Arming Confirmation
If remote unlock confirmation is on, the turn
signal lamps will flash briefly to let you know
when your alarm system has disarmed. If
you would not like the turn signal lamps to flash,
see DIC Vehicle Personalization (Uplevel Only)
on page 261.
Disarming with the Remote Keyless
Entry Transmitter
Your alarm system will disarm when you use your
remote keyless entry transmitter to unlock the
doors. The security light will stop flashing to let you
know the system is no longer armed.
Disarming with Your Key
Your alarm system will disarm when you use
your key to unlock the driver’s door. The security
light will stop flashing to let you know the
system is no longer armed. If you would like your
key not to disarm the alarm system, see DIC
Vehicle Personalization (Uplevel Only) on
page 261.
PASS-Key
®
III
Your PASS-Key
®
III system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry
Canada.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Changes or modifications to this system by other
than an authorized service facility could void
authorization to use this equipment.
PASS-Key
®
III uses a radio frequency transponder
in the key that matches a decoder in your vehicle.
135