Raymarine L365 GPS Receiver User Manual


 
59
silence the buzzer for the
current alarm condition
. The
“S” or “D” symbol will continue to flash as long as the alarm
condition is still present.
If the alarm condition occurs again, the buzzer will sound
again. (For example, this would happen if, after a shallow
alarm you move into deep water, then return to shallow
water.) You can silence the buzzer again by pressing the
CLEAR
button.
The Buzzer entry in the System Setup display allows you to
permanently silence the buzzer for all of the alarms. Use
the
< and > controls to turn this item on or off. The buzzer
symbol at the bottom of the screen will appear hollow.
Once you do this, if a shallow alarm or deep alarm occurs,
the “S” or “D” symbol will flash, but the buzzer will not
sound. You can enable the buzzer again at any time by
calling up the System Setup display, going to the line for
Buzzer, and turning the item on again. The buzzer symbol
at the bottom of the screen will appear solid.
Each time you press one of the buttons on the display
panel, the buzzer will beep. The buzzer will continue to
do this, regardless of the setting of the Buzzer option in the
System Setup display.
Depth Units This item sets the units used by the depth display. You can
choose feet (FT), fathoms (FA), or meters (M). Use the
<
and > controls to make your choice.
Speed Units This item sets the units used by the speed display. The
same units are used for the distance (“log”) display. There
are three choices:
Code Units used for speed Units used by log
MPH Miles per hour Statute miles
KTS Knots Nautical miles
KPH Kilometers per hour Kilometers
Setup Instructions