Filter
Top Products
7.30
FINAL DRIVE
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
6. Remove the bolt that attaches the rear bearing carrier to the
upper A-arm.
7. Slide the rear drive shaft out of the bearing carrier by
pulling the bearing carrier assembly outward and tipping it
down to remove the shaft.
8. Grasp the rear drive shaft and pull sharply outward on the
shaft to disengage it from the rear gearcase.
NOTE: Take care when removing to prevent
damaging the seal.
9. Inspect the axle splines and CV boots for any damage.
Outer CV Joint / Boot Replacement
1. Using a side cutters, cut away and discard the boot clamps.
2. Remove the large end of the boot from the CV joint and
slide the boot down the shaft.
3. Clean the grease from the face of the joint.
4. Place the drive shaft in a soft-jawed vise. Using a soft-faced
hammer, or brass drift, strike the inner race of the joint to
drive the joint off the drive shaft. Be sure to tap evenly
around the joint to avoid binding.
IMPORTANT: Tap on inner race only!
Brass Drift Shown