Pioneer CNDV-20 GPS Receiver User Manual


 
165
Chapter 7
Operating Your Navigation System with Voice
Chapter 7
Operating Your Navigation System with Voice
Basics of Voice Operation
Your Pioneer Navigation System comes with the latest in voice recognition technology. You can
use voice commands to operate many of its functions. This chapter describes where you can use
voice commands, and also what commands the system accepts.
Flow of voice operation
You can start voice operation any time even when the map screen is displayed or audio is
operated.
The basic steps of voice operation are as follows. The steps are almost the same as when
using the Remote Control.
With the “CD-SR80” Steering Remote Control (sold separately), you can press the BAND
button and the F button to switch on the operation mode of the Steering Remote Control.
When the operation mode is switched on, by pressing the BAND button of the Steering
Remote Control, you can activate voice operation, which is equivalent of pressing the TALK
button. (“CD-SR90” and “CD-SR100” can be used as well. For the details of their operation,
see the instruction manuals attached to them.)
When your Navigation System starts, you can also enter the password using your voice.
1. Press the TALK button to activate voice operation.
2. Speak a command into the microphone.
3. When the command is recognized, it is repeated.
4. As necessary, repeat Steps 2 and 3.
5. The voice command is carried out.