Filter
Top Products
8 C2924M (4/05)
Figure 1.
CCC1390H Series Camera
MODELS
CCC1390H-6 1/3-inch high resolution day/night, WDR, CCD camera, 24 VAC or 12 VDC, NTSC format
CCC1390H-6X 1/3-inch high resolution day/night, WDR, CCD camera, 24 VAC or 12 VDC, PAL format
ᕡ ᕢ
ᕥ ᕦᕤ
ᕨᕫᕾ
ᕧ
ᕩ
33
a
ᕡ Lens Mount: Mount a standard CS-mount lens to the CCC1390H Series camera (refer to Lens Mounting). To use a C-mount lens, install a
C/CS-mount adapter.
ᕢ Back Focus Locking Screw: Use a 1.5-mm Allen wrench to adjust the back focus (refer to Lens Focusing).
ᕣ Camera Mount and 3a Mount Adapter: Use the top or bottom mount hole. The maximum thread depth (top) is 0.188 inches (4.7 mm); the
adapter extends the thread depth (top) to 0.25 inches (6.4 mm). The maximum thread depth (bottom) is 0.25 inches (6.4 mm). Refer to Camera
Mounting.
ᕤ Serial Terminating Switch: Use this switch to terminate the serial signal at the last camera on the serial chain (refer to Connecting
External Control).
ᕥ Auto Iris Lens Connector: Insert the four-pin connector from the DC-drive auto iris lens into this connector (refer to Lens Mounting).
ᕦ Video Output Connector: Connect a coaxial video cable to this BNC connector to output the video image (refer to Connecting Video).
ᕧ Setup Button: Use this five-position button to configure the camera either directly (refer to Quick Setup) or through the setup menus (refer
to Accessing Setup Menus).
ᕨ Power Terminal Strip: Use this three-pin, push-in type terminal strip to connect either 12 VDC or 24 VAC power (refer to Connecting
Power).
ᕩ Indicators: Use these indicators to quickly determine camera status (refer to Quick Setup).
ᕫᕾ External Control Connector: Use this seven-pin connector to connect the camera to one or more serial devices. Use it also to connect an
external day/night filter switch. Refer to Connecting External Control for more information.