Filter
Top Products
C2924M (4/05) 13
Connecting Power, Video, and Control
The CCC1390H Series camera offers standard power and coax video connectors as well as an external control connector. Before installation,
identify how you will connect each power, video, and control lead to the camera.
CONNECTING POWER
The CCC1390H Series camera is designed to operate from either a 12 VDC or a 24 VAC power source. The camera automatically senses power
type. Use only a Class 2 isolated power source that can supply 12 VDC ±15% or 24 VAC ±15%, 50/60 Hz. Maximum power consumption is about
3.5 watts.
NOTES:
•
Be sure to use 60 Hz power for NTSC (CCC1390H-6) and 50 Hz power for PAL (CCC1390H-6X).
•
Install the camera near a socket or outlet that is easily accessible.
Use Table A to help you identify the necessary wire gauge and maximum cable distance. This table applies to two-conductor copper wire.
These maximum distances are based on a maximum allowable voltage drop of 10%.
WARNINGS:
•
Do not connect high voltage power to the camera because you may damage the camera.
•
Do not short circuit the power leads when connecting the power supply to the camera.
•
Do not remove the connector cover during camera operation.
Table A.
Recommended Wire Gauge and Maximum Wiring Distances
Wire Gauge
Maximum Distance
12 VDC 24 VAC
24 AWG (0.25 mm
2
) 373 ft (113 m) 224 ft (68 m)
22 AWG (0.35 mm
2
) 594 ft (181 m) 356 ft (108 m)
20 AWG (0.5 mm
2
) 945 ft (288 m) 567 ft (172 m)
18 AWG (1.0 mm
2
) 1,504 ft (458 m) 902 ft (372 m)
16 AWG (1.5 mm
2
) 2,388 ft (727 m) 1,432 ft (436 m)
14 AWG (2.5 mm
2
) 3,809 ft (1,160 m) 2,285 ft (696 m)
12 AWG (4.0 mm
2
) 6,037 ft (1,840 m) 3,622 ft (1,103 m)
10 AWG (6.0 mm
2
) 9,600 ft (2,926 m) 5,760 ft (1,755 m)