Filter
Top Products
34 C2924M (4/05)
5. To clear a character, select BS (backspace). The camera deletes the last character entered.
6. Repeat steps 3 and 4 until you have entered the camera title.
7. When the title is correct, select BACK to return to the TITLE menu.
CAMERA SETUP
Select this option to configure the serial communication and rear panel function settings for the
CCC1390H Series camera. Refer to Connecting External Control for information on wiring the serial
interface.
Address
The CCC1390H Series camera can be accessed remotely from selected Pelco controllers. Use this
option to assign a receiver address to the camera. This address identifies the camera on the serial
chain. Select a value from 1 to 30. The default is 1.
NOTES:
• Each camera must have a unique address.
• Be sure to assign the address before accessing the camera remotely.
COM Speed
Use this option to set the communication or baud rate for this camera. This must match the setting for the other cameras and controllers on the
serial chain. Select one of the following: 2400, 4800, 9600, 19200. The default is 4800.
LED
Select this option to enable or disable the rear panel indicators. The default is ON.
Switch
Select this option to enable or disable quick setup on the rear panel (refer to Quick Setup). The default is ON.
AUTO IRIS LENS ADJUSTMENT
Select this option to adjust the electronic properties of the auto iris lens to the auto iris electronic
properties of the camera. Perform this procedure before using the camera or each time you change
the lens.
To perform this procedure:
1. Mount the auto iris lens to the camera (refer to Lens Mounting).
2. Aim the camera at a bright, flickerless scene.
3. Select AI AUTO ADJUSTMENT. The AI AUTO ADJUSTMENT menu appears.
4. Select OK. The camera performs the procedure. Then the MAIN MENU appears.
CAMERA SETUP
ADDRESS > 1
COM SPEED > 4800
LED > ON
SWITCH > ON
BACK EXIT
AI AUTO ADJUSTMENT
OK CANCEL