Filter
Top Products
32 C2924M (4/05)
MANUAL RED/BLUE
Select this option to display the MANUAL RED/BLUE menu.
Red Gain
Use this option to either increase or decrease the light level of the red elements in the camera image.
Select a value between -5 and 5. The default is -1.
Blue Gain
Use this option to either increase or decrease the light level of the blue elements in the camera image. Select a value between -5 and 5.
The default is -2.
Red Hue
Use this option to either increase or decrease the red hue in the camera image. Select a value between -5 and 5. The default is 1.
Blue Hue
Use this option to either increase or decrease the blue hue in the camera image. Select a value between -5 and 5. The default is 1.
GAMMA
Gamma correction adjusts the video signal to compensate for the nonlinear response of the monitor display.
Select one of the following options: 60%(NORM), 45%, or 100%. The default depends on the selected profile (refer to Table G).
NOTE: When AUTO EXPOSURE is set to WDR, you cannot change the gamma setting.
SHARPNESS
Select this option to display the SHARPNESS menu.
Aperture Gain
Use this option to increase or decrease the image sharpness, both vertically and horizontally. Select
a value between -5 and 5. The default is -1.
E-ZOOM
Select this option to configure electronic zoom, including electronic panning.
NOTE: When you enable electronic zoom, both the WDR auto exposure mode and masking are
disabled. If either WDR or masking is active, electronic zoom is disabled.
Zoom
Select one of the following electronic zoom options: OFF, 1.5, 2.0, 2.5. The default is OFF.
Position
Use this option to pan and tilt the electronic zoom frame to a specific portion of the scene.
To position the electronic zoom frame:
1. Change the ZOOM setting on the E-ZOOM menu to 1.5. Positioning is possible only at 1.5 zoom.
2. Select the POSITION menu. The POSITION menu appears.
3. Press the button up, down, left, or right to position the frame. When correct, press the center of the button to return to the E-ZOOM menu.
4. To use 2.0 or 2.5 zoom, change the ZOOM setting to the desired value.
MANUAL RED/BLUE
RED GAIN > -1
BLUE GAIN > -2
RED HUE > 1
BLUE HUE > 1
BACK EXIT
SHARPNESS
APERTURE GAIN > -1
BACK EXIT
E-ZOOM
ZOOM > OFF
POSITION >
BACK EXIT
POSITION