Filter
Top Products
5. Wipethe engineoil filtersealing surfacewith
a clean rag.
CAUTION
Be sure to remove any old gasket material
remaining on the sealing surface of the
engine. Failure to do so could lead to an
oil leak and engine damage.
6. Coat the gasket on the new filter with clean
engine oil.
7. Screw onthe oil filter untila slight resistance
is felt, then tighten an additional 2/3 turn.
8. Start the engine and check for leakage
around the oil filter. Correct as required.
9. Turn the engine off and wait more than 10
minutes. Checkthe oil level. Addengine oil if
necessary.
When checking or replacement is required, we
recommend your NISSAN dealer for servicing.
CAUTION
● Use Genuine NISSAN Matic S ATF. If
Genuine NISSAN Matic S ATF is not
available, Genuine NISSAN Matic J ATF
may also be used.
● Using automatic transmission fluid
other than Genuine NISSAN Matic S
ATF or Matic J ATF will cause deteriora-
tion in driveability and automatic trans-
mission durability, and may damagethe
automatic transmission, which is not
covered bythe NISSAN new vehiclelim-
ited warranty.
The specified automatic transmission fluid is also
described on cautionlabels located inthe engine
compartment.
The fluid level should be checked using the HOT
MAX range on the power steering fluid reservoir
at fluid temperatures of 122° - 176°F (50° -
80°C) or using the COLD MAX range on the
power steering fluid reservoir at fluid tempera-
tures of 32° - 86°F (0° - 30°C).
If the fluid is at or below the MIN line, add Genu-
ine NISSAN PSF to HOT MAX or COLD MAX
depending on system fluid temperature. Remove
the cap and fill through the opening.
WDI0256
5-SPEED AUTOMATIC
TRANSMISSION FLUID
POWER STEERING FLUID
Maintenance and do-it-yourself 8-11
੬ REVIEW COPY—
2010 Armada (wzw)
Owners Manual (owners)—USA_English (nna)
02/18/09—debbie
੭