Filter
Top Products
3. Using both hands, simultaneously pressand
hold boththe HomeLinkா buttonyou want to
program and the hand-held transmitter but-
ton.
DO NOT releasethe buttonsuntil step 4has
been completed.
4. Hold down both buttons until the indicator
light on the HomeLinkா flashes, changing
from a “slow blink” to a “rapidly flashing
blink”. This could take up to 90 seconds.
When theindicator lightflashes rapidly, both
buttons may be released. The rapidly flash-
ing light indicates successful programming.
To activate the garage door or other pro-
grammed device, press and hold the pro-
grammed HomeLinkா button — releasing
when the device begins to activate.
5. If the indicatorlight on the HomeLinkாblinks
rapidly for 2 seconds and then turns solid,
HomeLinkா has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLinkா to complete the programming
which may require a ladder andanother per-
son for convenience.
6. Press and release the “smart”or “learn”pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, youwill need to removethe lens to
access the program button.
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light”is lit, you
have 30seconds in whichto perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
7. Within 30 seconds of pressing and releas-
ing the garage door opener’s program but-
ton, quickly and firmly press and release the
HomeLinkா button you’ve just programmed.
Press and release the HomeLinkா button up
to 3 times to complete the training.
8. Your HomeLinkா button should now be pro-
grammed. (To program the remaining
HomeLinkா buttons for additional door or
gate openers, follow steps 2-4 only.)
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLinkா buttons.
If you have any questions or are having difficulty
programming your HomeLinkா buttons, refer to
the HomeLinkா web site at: www.homelink.com
or call 1-800-355-3515.
PROGRAMMING HOMELINKா FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2 sec-
onds. To program your hand-held transmitter to
HomeLinkா, continue to press and hold the
HomeLinkா button (see steps2-4under “Pro-
gramming HomeLinkா”) while you press and re-
press (“cycle”) your hand-held transmitters every
2 seconds until the indicator light flashes rapidly
(indicating successful programming).
WIC0987
Instruments and controls 2-59
੬ REVIEW COPY—
2010 Armada (wzw)
Owners Manual (owners)—USA_English (nna)
03/09/09—tbrooks
੭