Filter
Top Products
OUTPUT TERMINAL PANEL FAMILIARIZATION
Loads can be connected to the generator by the Output
or the convenience receptacles (Figure 12).
Make sure to read the operation manual before attempting
to connect a load to the generator.
To protect the output terminals from overload, a 3-pole,
400A main circuit breaker is provided. Make sure to switch
circuit breakers to the OFF position prior to starting
the engine.
Figure 12. Connecting Loads
Over Current Relay
An over current relay (Figure 13) is connected to the main
circuit breaker. In the event of an overload, both the circuit
breaker and the over current relay may trip. If the circuit
breaker can not be reset, the reset button on the over
current relay must be pressed. The over current relay is
located in the control box.
Figure 13. Over Current Relay