Filter
Top Products
DIAGNOSTIC DISPLAY
Diagnostic Display has not received any CAN messages for at least 30 seconds.
NO DATA
Diagnostic Display has not received the particular message being displayed for at least 5 seconds.
NOT SUPPORTED
Diagnostic Display has received a message from the ECU stating the displayed message is not supported
DATA ERROR
Diagnostic Display has received an error message from the ECU for the displayed message.
No parameter selected for this 4- UP quadrant.
This is a message from the engine indicating it is in a preheating cycle.
Wait until this message clears before starting the engine.
The ECU did not respond to the PowerView request.
NO GAGE DATA
The Diagnostic Display has no record of connected gages to the RS485 bus.
Press and hold the “Menu” button for approximately 3 seconds.