Filter
Top Products
Fuses
329
X
If engaged, release the parking brake.
X
Switch on the hazard warning flasher
(Y page 98).
!
The vehicle may be towed only for distan-
ces up to 30 miles (50 km) and at a speed
not to exceed 30 mph (50 km/h).
i
To signal turns while being towed with the
hazard warning flasher in use you can acti-
vate the combination switch for the left or
right turn signal in the usual manner – only
the selected turn signal will operate. Upon
canceling the turn signal, the hazard warn-
ing flasher will operate again.
Fuses
Introduction
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operating.
G
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or
the fuse rating given on the fuse) of the
amperage recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to
advise you on this subject.
i
In case of a blown fuse contact Roadside
Assistance or an authorized Mercedes-
Benz Center.
If a newly inserted fuse blows again, have the
cause determined and rectified by an author-
ized Mercedes-Benz Center.
A fuse chart is located in the fuse box in the
passenger compartment. The fuse chart
explains the fuse allocation and fuse amper-
ages.
The electrical fuses are located in fuse boxes
in the passenger compartment or in the trunk.
Before replacing fuses
X
Engage the parking brake.
X
Make sure the automatic transmission is in
park position P.
X
Switch off all electrical consumers.
X
Turn off the engine.
X
Remove the SmartKey from the starter
switch.
X
Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position 0, same as with the SmartKey
removed from the starter switch). The
driver’s door then can be closed again.
Practical hints
Z