Filter
Top Products
Control system
132
certain systems. They do not replace the
owner’s and/or driver’s responsibility to
maintain the vehicle’s operating safety.
Have all required maintenance and safety
checks performed on the vehicle. Bring the
vehicle to an authorized Mercedes-Benz
Center to address the malfunction and
warning messages.
X
Press button è or ÿ repeatedly until
the Vehicle status message memory
menu appears in the multifunction display.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the multifunction dis-
play:
X
Press button j or k.
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see “Vehicle status messages in the multi-
function display” (Y page 255).
Should the vehicle’s system record any con-
ditions while driving, the number of messages
will reappear in the multifunction display
when the SmartKey in the starter switch is
turned to position 0 or removed from the
starter switch. With KEYLESS-GO the number
of messages will reappear when you turn off
the engine by pressing the KEYLESS-GO
start/stop button and open the driver’s door.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you turn off the ignition.
Settings menu
Introduction
In the Settings menu there are two func-
tions: The function To reset, press reset
button for 3 seconds., with which you
can reset all the settings to the original fac-
tory settings and a collection of submenus
with which you can make individual settings
for your vehicle.
The following settings and submenus are
available in the Settings menu:
R
Resetting to factory settings (Y page 132)
R
Submenus in the Settings menu
(Y page 133)
R
Instrument cluster submenu (Y page 134)
R
Lighting submenu (Y page 135)
R
Vehicle submenu (Y page 138)
R
Convenience submenu (Y page 138)
Resetting to factory settings
You can reset the functions of all submenus
to the factory settings.
For safety reasons, the function Headlamp
Mode in the Lighting submenu cannot be
reset while driving.
X
Press button è or ÿ repeatedly until
the Settings menu appears in the multi-
function display.
Controls in detail