Filter
Top Products
Vehicle status messages in the multifunction display
267
Tires
Display messages Possible cause/consequence Possible solution
Check tires, then restart Run
Flat Indicator.
There was a warning message about a loss
in the tire inflation pressure and the Run
Flat Indicator has not been restarted yet.
X
Make sure the correct tire inflation pressure is
set for each tire.
X
Then restart the Run Flat Indicator
(Y page 213).
Run Flat Indi-
cator Inopera-
tive
The Run Flat Indicator is malfunctioning.
X
Have the Run Flat Indicator checked at an
authorized Mercedes-Benz Center.
Tire Pressure Check tires
The Run Flat Indicator indicates that the
pressure is too low in one or more tires.
X
Carefully bring the vehicle to a halt, avoiding
abrupt steering and braking maneuvers.
Observe the traffic situation around you.
X
Check and adjust tire inflation pressure as
required (Y page 212).
X
If necessary, change the wheel (Y page 314).
X
Restart the Run Flat Indicator after adjusting
the tire inflation pressure values
(Y page 213).
Tire pressure is only displayed
after driving for a
few minutes.
Vehicles with Advanced TPMS (Canada
only): The tire inflation pressure is being
checked.
X
Drive the vehicle for a few minutes.
Practical hints
Z