Filter
Top Products
340
Controls in detail
Useful features
Step 9:
̈ Press the “training” button on the
garage door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the
following step.
Step 10:
̈ Return to the vehicle and firmly
press, hold for 2 seconds and release
the programmed signal transmitter
button (2, 3 or 4).
Step 11:
̈ Press, hold for 2 seconds and release
same signal transmitter button a
second time to complete the training
process.
Step 12:
̈ Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or 4).
Step 13:
̈ To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
̈ While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this
sequence on the hand-held remote
control until the frequency signal has
been learned. Upon successful train-
ing, indicator lamp 1 will flash slowly
and then rapidly after several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
i
Some garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.
୴୴