Filter
Top Products
188
Controls in detail
Control system
̈ Press button j or k repeatedly
until the message
Compass Calibra-
tion
appears in the multifunction
display.
The selection marker is on setting
switched off
.
̈ Press button æ to set the selection
marker to
Start
.
The following message appears in the
multifunction display:
Compass Calibration active
Please drive in a full circle
̈ Drive a full circle at a vehicle speed
of between 3 mph and 6 mph
(5 km/h and 10 km/h).
When calibration was successful, the
following message appears in the
multifunction display:
Compass calibration
Completed successfully
Audio search function
Use of the Audio search function to
select a radio station (
୴ page 171) will
enable you to start a frequency scan
(
Freq.
) or select a radio station stored in
memory (
Memory
).
̈ Move the selection marker with
button æ or ç to the
Vehicle
submenu.
̈ Press button j or k repeatedly
until the message
Audio Search
function
appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press button æ or ç to select
Freq.
or
Memory
.
i
If the message
Compass calibration
Completed successfully
does not appear in
the multifunction display, drive another full
circle.
If calibration does not succeed within 3 minutes,
the message
Compass Calibration
appears
in the multifunction display again. Calibrating the
compass has failed due to outside influences.
Repeat compass calibration in a different
location.
୴୴